FSCUT 4000 Cypcut Fiber Laser Cutting Machine Fiber Laser Controller System
Basic introduction
FSCUT4000 laser cutting system is a high-speed, high-precision full-closed-loop laser control system independently developed earlier in China. Advanced functions such as automatic adjustment, cross-coupling control, intelligent perforation are supported.
Feature
1.Craft
Arbitrary combination of subsection or progressive, fixed height zoom perforation and other intelligent perforation methods.
Support pre-piercing, grouping pre-piercing, cooling point, stop light blowing, sharp corner ring cutting and other thick plate processes.
Support flying car detection, automatic adjustment, capacitive edge finding, electric focusing, exchange table, multi-task processing, automatic layout, flying cutting, leapfrog, two-dimensional code, cutting line, maintenance and other advanced functional modules.
Supports automation applications such as simple scheduling, virtual multi-station, and scanning code.
Support starting, closing and fine cutting processes.
2.Control
The closed-loop control system adopts the fourth-generation motion control algorithm of Bochu.
Control accuracy 0.005mm, actual trajectory accuracy 0.01mm, positioning accuracy 0.001mm, repeat positioning accuracy 0.002mm.
Maximum cutting speed 80m/min. Maximum air moving speed 200m/min.
Maximum acceleration 2.5G.
Allah's slave axis dual drive, each axis cross-coupling control, speed and acceleration look-ahead.
Applicable Industries
Suitable for high-precision laser processing equipment. Widely used in 3C industry, brittle and thin materials such as glass ceramics, polymer films, glasses accessories and other precision processing occasions.
 |
| FSCUT 4000 |
Specification
| Adaptation software | CypOne Laser Cutting Software |
| Control card | BMC1214 |
| Interface Type | 32-bit PCI bus, 132MB/s |
| Terminal board | BCL3724 |
| Power Requirements | 24V DC/2A |
| Motor control signal | X/Y1/Y2/W axis analog output, -10~+10V
X/Y1/Y2/W axis with encoder input interface, the highest sampling frequency is 10MHz |
| Dedicated output | 4-channel DA: 0~10V, 50mA
1 channel PWM: 5V/24V optional, accuracy 50KHz (0.1%) |
| Dedicated input | 4-way origin: active low, support normally open and normally closed
8-way limit: active low, support normally open and normally closed |
| Universal input | 12 channels: active low, support normally open, normally closed
IN10/11/12 support jumper changed to active high |
| Universal output | Relay output 6 channels: Load capacity: 250V AC/5A, 30V DC/5A
Thyristor output 14 channels: load capacity: 24VDC/500mA |
| Working environment | Temperature: 0~55℃
Humidity 5%~95% (non-condensing) |
Product Tags:
|
|
FSCUT 4000 Cypcut Fiber Laser Cutting Controller System High Speed Images
|
